Your Keyvibe device detects the state of your machine (producing or stopped) by analyzing vibrations. It sends this data in real time to your Keyprod platform, with no screen and no wiring on the machine.
Pack contents
Technical description
Prerequisites
- Make sure there is a power outlet near the machine to power the device
- Make sure your IT team has allowed the device to access the internet (network prerequisites)
- Check that your device is assigned to a machine on your Keyprod platform (assignment procedure)
Installing your device
Step 1: Placing it on your machine
Attach your Keyvibe device magnetically, directly onto the machine. Correct positioning is essential for reliable state detection:
- Choose an area where the vibration reflects the actual production activity
- Avoid areas close to fans, pumps or extractors (sources of interfering vibrations)
- The device has no screen: operator readability is not a constraint, so you can prioritize the quality of the vibration signal
Refer to the article Positioning your Keyvibe device for a detailed guide.
Step 2: Connecting to power
Plug the power cable into the device, then into the mains. The LEDs light up progressively during startup. Wait 2 to 3 minutes for the device to initialize and connect to the network.
Step 3: Connecting to the network
The Keyvibe connects to the network via WiFi or RJ45.
- WiFi: the initial WiFi network configuration requires a direct connection to the device. Contact your Keyprod representative for assistance during commissioning
- RJ45: plug a network cable into the device's RJ45 port. The device automatically obtains an IP address via DHCP
Step 4: Checking connectivity
Check the LED status to make sure the device is properly connected and operational.
Refer to the article Keyvibe connectivity to interpret each LED.
Step 5: Configuring downtime detection
Once the device is connected:
- Log in to your device's configuration interface (see the dedicated article)
- Configure the detection parameters (threshold, delay, sensitivity) according to your machine's activity